Learn how to do an oil change on your Nissan Altima with this instructional automotive repair video.
1. Remove the protective shroud that is located above the actual oil filter. This shroud will stop debris on the highway from doing damage to your oil filter. (00:15)
2. The oil filter is located to the left on the passenger side of the car. You can use an approved oil wrench tool, (check with your parts supplier) and after it is loose remove it the rest of the way by hand. It is important to not cross thread the filter or the threads on the pan. (00:23)
3. now you will notice that there is a plug on the back of the oil pan. This will be tight and should be broken loose by using a wrench. Finish removing the plug by hand being very careful not to drop it or lose it. Drain the oil out of the engine and into a pan so that the oil can be recycled. Oil does not wear out and can be cleaned up and reused. After oil has drained, install the threaded plug by hand and snug tight with a wrench at the end. Please note that you should check the gasket on the plug and replace if it is broken or torn. (00:58)
4. As mentioned before, use an oil filter wrench to loosen the filter, then remove by hand. Before installing the new oil filter, apply a light coat of clean oil on the gasket located on the top of the filter. This will help the filter to seat properly. Install new filter by hand careful not to cross thread as you install it. (01:30)
5. Remove the threaded oil cap on top of the engine. This cap is clearly marked. Set the cap somewhere safe so that you will not lose it or damage it. Use a funnel so that you don’t make a mess that you will have to clean up later. Pour in a light viscosity oil or check with your parts supplier regarding the best oil for your car based on driving habits, environment and how often that you want to change oil. Go ahead and replace cap to hand tight. (02:02)
6. Make sure that the car is positioned on a flat surface and check the oil with the dipstick. (02:25)
May 8th, 2008 at 08:33 PM Are these videos supposed to have sound?